Note: AirPort Admin Utility for Graphite and Snow 4.2.5 does not currently work with Mac OS X 10.6 or later. You can locate it using Sherlock prior to Mac OS X 10.2, or the Find dialog of the Finder in Mac OS X 10.2 or later. Note: The location of this utility varies with different operating system versions. Open AirPort Admin Utility for Graphite and Snow 4.2.5.In the case of the Graphite base station, if the middle light glows green, you pressed the reset button too late. Press and hold the reset button for 30 seconds until the middle AirPort base station status light turns on.When all three status lights light up, insert a pen, pencil, or straightened paperclip into the reset button hole on the bottom of the base station.Disconnect the power adapter from the base station and then reconnect it.You may notice a brief system delay after closing the control panel. You can connect directly to the base station using an Ethernet crossover cable, or you can connect through an Ethernet switch using standard Ethernet cables. Connect your computer to the AirPort base station using Ethernet.The base station will use the new settings after it has restarted. Make changes to passwords or any other settings you require, then click Update.If you turn on encryption, enter a new password for your AirPort network. Turn encryption on to activate password protection for your AirPort network.IP address: Unless you have been given an IP address by your Internet service provider or system administrator, do not change the IP address.This allows you to make the following changes: Select the base station and click Configure.Open AirPort Admin Utility for Graphite and Snow.From the AirPort menu bar item, choose the network created by the base station (the network name does not change).You can connect to the soft reset base station using the following manual network settings on your computer: You can locate it using Sherlock prior to Mac OS X 10.2, or the Find dialog of the Finder in Mac OS X v10.2 or later. ![]() Use AirPort Admin Utility for Graphite and Snow 4.2.5 to reconfigure the base station.The base station password is set to "public" and the IP address is reset.The middle LED will blink once every second while the device is in soft reset mode.Insert a pen, pencil, or straightened paperclip through the hole where the reset button is located and press and hold it for one full second.What default settings will my AirPort base station have after a hard or factory default reset? If you choose, you may manually erase the hard drive using AirPort Utility. Data stored on internal or external hard drives connected to the device will not be erased. This reset resets the device to its state when you first purchased it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |